12 TON Finger Brake DIY Builder Kit
Press Brake kit comes unassembled, you do the final assembly and welding.
Designed to fit the Harbor Freight 12 ton hydraulic press Item # 33497
Press brake kit includes an adjustable back stop and side stop for accurate and repeatable bends.
The top clamping bar is machined out of 4140 material and includes 3 segmented removable sections. 1", 3", and 9.5" long pieces. These segmented blocks can be removed and rearranged to allow bending of restricted areas on a piece of sheet metal or on an already partially formed pieces.
- Max Bending Radius (deg.) 110
- Max. Bending Capacity 3/8" plate
- Max Bending Width 13.50"
- Total width of the brake is 16.375" wide
Tools required for assembly, welder, grinder, level, small square.
It Is capable of bending mild steel in the following length and thickness.
- 13.50" = Full bending width of the bottom die on anything 1/8" or thinner.
- 8" in 3/16"
- 6" in 1/4"
- 2.5" in 3/8"
The DIY 12 ton finger press makes a great addition to the arbor press plates we sell HERE.
PRESS BRAKE ASSEMBLY INSTRUCTIONS
Free shipping, how it this possible? We recently produced a new box that allows us to fit the 12 and 20 ton press brake kits into a large flat rate USPS shipping box. We wrapped up the cost of shipping in the purchase price of the kit as our website shipping calculator has no idea how we can transport up to 69 lbs from Oregon to New York for $20.00. Upon check out please provide an address that USPS delivers too.
We now offer the press brake kits 100% fully welded ready to go right out of the box. This offer only applies to the continental united states as the welded assemblies no longer fit inside a flat rate USPS box and they will need to ship UPS ground. The additional shipping fees required are wrapped up in the product cost of the welded product.