12 TON Press Brake DIY Builder Kit
Press Brake kit comes unassembled, you do the final assembly
Designed to fit the Harbor Freight 12 ton hydraulic press Item # 33497
Press brake kit includes an adjustable back stop and side stop for
accurate and repeatable bends.
Max Bending Radius (deg.) 110
Max. Bending Capacity 3/8" plate
Max Bending Width 13.85"
Total width of the brake is 16.375" wide
Tools required for assembly, welder, grinder, level, small
It Is capable of bending mild steel in the
following length and thickness.
= Full bending width of the bottom die on anything 1/8" or thinner.
- 8" in 3/16"
- 6" in 1/4"
- 2.5" in 3/8"
The DIY 12 ton press makes a great addition to the arbor press
plates we sell HERE
PRESS BRAKE ASSEMBLY INSTRUCTIONS
shipping, how it this possible? We recently produced a new box that
allows us to fit the 12 and 20 ton press brake kits into a large flat
rate USPS shipping box. We
wrapped up the cost of shipping in the purchase price of the kit as our
website shipping calculator has no idea how we can transport up to 56
lbs from Oregon to New York for $20.00. Upon check out please provide an address that USPS delivers too.
now offer the press brake kits 100% fully welded ready to go right out
of the box. This offer only applies to the continental united states as
the welded assemblies no longer fit inside a flat rate USPS box and they
will need to ship UPS ground. The additional shipping fees required
are wrapped up in the product cost of the welded product.