 |
| |
 |
| |
 |
| |
 |
| |
 |
| Phone (541) 915-2775 |
 | Press Brake kit comes unassembled, you do the final assembly and welding. | |
| Designed to fit the Harbor Freight 20 ton press. | |
| Press Brake includes adjustable back stop and side top for accurate repeatable bends. | |
| Max Bending Radius (deg.) 110 | |
| Max. Bending Capacity 3/8" plate | |
| Max Bending Width 19.25" | |
| Total width of the brake is 22.125" wide | |
| Tools required for assembly, welder, grinder, level, small square. | |
| The DIY 20 ton press makes a great addition to the arbor press plates we sell HERE | |
| It Is capable of bending mild steel in the following length and thickness. |
19" = Full bending width of the bottom die on anything 1/8" or thinner.
15" in 3/16"
12" in 1/4"
5" in 3/8"
| The DIY builder kit includes the following parts: |
Side stop
Back stop
.75" x 4.0" Top machined die
Bottom die 2.0" wide
Back stop guide rails
Top die guide rail rod
Top die guide rail DOM tubing
Top die ram center 1.75" dia tubing
(2) 3" threaded rods
(2) Shaft collar locks
(2) Springs
Misc fasteners
Detailed Instructions
| 20 TON Press Brake DIY Builder Kit |
All Shipping is Based on Lower 48 States
|
| Same quality construction and number of components as the standard press brake kit, just built out of high | |
| strength 3/8" steel and a wider bottom die 4.0" wide to allow for easier bending of thicker material. | ||
| It Is capable of bending mild steel in the following length and thickness. |
19" = Full bending width of the bottom die on anything 3/16" or thinner.
15" in 1/4"
13" in 5/16"
11" in 3/8"
6" in 1/2"
3" in 5/8"
All Shipping is Based on Lower 48 States
HD 20 TON Press Brake DIY Builder Kit
|
| You asked for it ..........& here it is. | |
| Constructed out of high strength 3/8" steel with a 1.0" x 4.0" thick top die and 3.0" wide bottom die. | |
| This universal press brake kit will bend steel up to 37.5" wide and is designed to fit in hydraulic presses that are at least 40" wide between the | |
| vertical beams, however it kit can easily be cut down or modified to accommodate smaller presses. | ||
| Note due to the custom nature of this kit it does not come with an adjustable back or side stop. | |
| Note max bending width and thicknesses are determined upon your hydraulic press and thus actual numbers are dependant upon your press. | |
40" Universal Press Brake DIY Builder Kit
All Shipping is Based on Lower 48 States