40" Universal Finger Press Brake DIY Builder Kit, With Adjustable Back Stop.
Press brake kit comes un-assembled, you do the final assembly
You asked for it ..........& here it is.
Constructed out of high strength 3/8" steel with a
1.0" x 4.0" thick top die and 3.0" wide bottom die. The kit is shipped with fingers in the following sizes, 1", 2", 3", 4", 9.5" & 17" long.
This universal press brake kit will bend steel up to
37.5" wide and is designed to fit in hydraulic presses that are at least
40" wide between the vertical beams, however it kit can easily be cut down
or modified to accommodate smaller presses.
Note, due to the custom nature of this kit the
max bending width and thicknesses are determined by your hydraulic
press. Assuming you have 40 tons of downward pressure evenly distributed across the top die by two 20 ton
bottle jacks, you will be able to bend full width of 3/16" A-36 steel.
Tools required for assembly, welder, grinder, level, small
Check out the first link below for a fully detailed list of material needed to create your own I beam press brake stand...which is less work than your probably thinking & fairly inexpensive, considering what it allows you to create.
SWAG 40" FINGER BRAKE WITH CUSTOM I BEAM STAND
PRESS BRAKE ASSEMBLY INSTRUCTIONS