50" Press Brake DIY Builder Kit
Press brake kit comes unassembled, you do the final assembly
You asked for it ..........& here it is.
Constructed out of high strength 3/8" steel with a
1.0" x 4.0" thick top die and 3.0" wide bottom die.
This universal press brake kit will bend steel up to
49" wide and is designed to fit in hydraulic presses that are at least
52" wide between the vertical beams, however it kit can easily be cut down
or modified to accommodate smaller presses.
The max bending width and thicknesses are determined upon
your hydraulic press and thus actual numbers are dependent upon your press.
Tools required for assembly, welder, grinder, level, small
out the first link below for a fully detailed list of material needed
to create your own I beam press brake stand...which is less work than
your probably thinking & fairly inexpensive, considering what it
allows you to create.
PRESS BRAKE ASSEMBLY INSTRUCTIONS