

Incra V27 Miter Gauge

You may also like
A handy addition to the Swag portaband stand. helps make straight cuts!
Works great with the swag saw table
The price was way too high for this and it fits too loose in the table Update- thanks for the tip about the tiny allen wrench. By kit came with no instructions at all so i didnt know what it was for as it fell out of the packaging by itself. Good thing i kept it!
Easy to set up and square in and take up the play out of the slide
Well made. I really like the locking feature.
- 5 stars: 13 (100%)
- 4 stars: 0 (0%)
- 3 stars: 0 (0%)
- 2 stars: 0 (0%)
- 1 star: 0 (0%)
A handy addition to the Swag portaband stand. helps make straight cuts!
Works great with the swag saw table
The price was way too high for this and it fits too loose in the table Update- thanks for the tip about the tiny allen wrench. By kit came with no instructions at all so i didnt know what it was for as it fell out of the packaging by itself. Good thing i kept it!
Easy to set up and square in and take up the play out of the slide
Well made. I really like the locking feature.
EVERYTHING CAME AS SAID USING IT ALL TOMORROW SO ILL SEND A COMMENT
I own dime-store miters and this one is 180 degrees from those. It's a well-built unit that fits the bandsaw table very well. Nice job!
I ordered the miter for my table at the same time and is used with my Milwaukee bandsaw. I was having to do some precision cuts at 23 1/2° and there is no indent for that in the miter. I cannot lock the miter down tight enough with the thumb nut, so that was a bit annoying that I could not screw it down enough to hold that angle. I just put a spacer on one side to get the extra degree I needed.
I haven't had an opportunity to use it yet, but my visual review is great; better then my other ones.
Good quality, would buy again.
Nice table will do what I want. Does sag just a little with saw on it but I can live with it making table uneven. Overall great little table great price point. 5 star dp
Hello,
Thank you for your review and kind words regarding your new Portaband Table.
On the new Milwaukee table, the last thing we do before we ship it out is preload the table top in order to counter act the sag that occurs as a result of the saw's weight on the rear edge. It sounds like we might have under bent yours which is why you are experiencing some sag. Fortunately, this is quiet easy to fix. Take the saw off of the table and use a large pair of channel locks or a large crescent wrench to slightly bend up the back left hand side of the plate up a degree or two.
It sounds a bit crude however it works every time and once it is adjusted it will never need to be be adjusted again.
Don't hesitate to reach out if there is anything we can help you with.
Thank you,
SWAG Off Road
Good quality, fully adjustable to dial-in the squareness with the blade. I bought it to use with the portaband table and I found it to be a little big (long) and cumbersome. This is just due to the matching of products together and not an inherent quality of the miter gauge itself which is very good.
This is a great addition to the bandsaw table. Makes holding materials easy and safer. Top quality.





















