if (location.protocol != 'https:')
A simple clip on
magnetic upgrade for your JD² Notchmaster, JD² Beast, or the Woodward Fab
notcher WFN-6, that instantly adds much needed versatility that is currently
lacking on your tubing notcher........notching on a bend.
If you own the Notchmaster, Beast or
the WFN-6 tubing notcher, then you know how truly awesome this little add on
can be. The GOAT allows you to do notches and fabricate parts that you were
never able to do before.
The GOAT will allow you to tackle
any project from this point forward without limitations, or go about producing
parts that were just too difficult previously.
Constructed out of laser cut
3/8" thick steel with countersunk neodymium magnets that are threaded into
the back side of the jaws. The two neodymium magnets do a great job at
holding the Goat in place while you manipulate your tubing to be notched.
The 1/2" dia "D" profile shaft is constructed out of stainless
steel to maintain strength and reduce corrosion. The center jaw is
designed to float along the stainless-steel shaft to accommodate any size
material at any bend angle while ensuring your tubing is firmly held in place.
Combine this product with our Reach Around Arm and the Super Shaft and
you have a notcher that will out work any notcher out there for less
<iframe width="640" height="360" src="https://www.youtube.com/embed/fPjYNEGOz2E" frameborder="0" allow="accelerometer; autoplay; encrypted-media; gyroscope; picture-in-picture" allowfullscreen></iframe>