SWAG Machined Thumb Knob For (Round) Hydraulic Bottle Jack Release Valves

SWAG Machined Thumb Knob For (Round) Hydraulic Bottle Jack Release Valves

review
5
0
5
Your Price: $14.95
Free Shipping
Part Number:ACCTBMTK
  • This Item Ships Using (USPS), Please Provide A Suitable Shipping Address:

Machined Thumb Knob For Bottle Jacks “Round”Open/Close Valves

We save you the hassle of using the 18" long handle to open and close the pressure release valve on any of your bottle jacks or long rams. It is fully machined out of steel with a black oxide finish and built to last.

To install you simply press out the roll pin on the ram, slide over the SWAG machined thumb knob then reinstall the roll pin.


Note: If your bottle jack release valve has a flared or "smashed" end, or a cast cross pin, you will need our 3-D printed thumb knob which can be found HERE.


5 Stars
Great accessory
My newer HF press had a different style than the roll pin. Took the screw out of the jack, ground just a bit off the diameter, and pressed right in the knob snug. Makes it much easier to release the jack.
Reviewed by:  from Burleson, Tx. on 10/4/2017
5
5 Stars
THUMBS KNOB WORTH EVERY PENNY
THEY WILL SAVE MORE TIME THAN YOU CAN IMAGINE! BUY ONE FOR EVER BOTTLE JACK YOU OWN.
Reviewed by:  from GRAND RAPIDS. on 9/11/2017
5
5 Stars
C3 Corvette Guru
This is without a doubt the best invention since popcorn. Makes life a whole lot easier!
Reviewed by:  from Spring, Texas. on 8/28/2017
5
5 Stars
I wish I had this years ago.
If you don`t have this you need it. What a great item.
Reviewed by:  from Hingham. on 8/8/2017
5
5 Stars
Offroader
This knob works perfectly. Just what what was needed to make my hydraulic jack work better with my Swag 20ton press!!
Reviewed by:  from Long Beach Ca.. on 6/4/2017
5
5 Stars
Great product
I ordered 2 of these, one for the Hazard Fraught press I have which has the roll pin to turn the bleeder screw and it went on and works perfect. I also have a 20 ton bottle jack on another device that has the smashed style which I wasn't remembering for some reason. I just took an angle grinder and kind of squared it up so the knob would fit and lined it up and drilled a 9/64 hole and used a 1/8" roll pin designed for an AR-15 trigger guard to secure it. works fine. great product you have there.
Reviewed by:  from Hanford, ca. on 11/17/2019
5
5 Stars
Great additon to my old junk bottle jack
I installed this on the old bottle jack on my press and I love it. You should buy one for sure.
Reviewed by:  from Texas. on 11/5/2019
5
5 Stars
Excellent
This knob make the press so much easier to use. No more fiddling with jack handle. I wish I would have bought this sooner.
Reviewed by:  from Minneapolis. on 11/4/2019
5

Related Items

 

Recently Viewed Items